(Computed tomography number) The CT number is a selectable scan factor based on the Hounsfield scale. Each elemental region of the CT image (pixel) is expressed in terms of Hounsfield units (HU) corresponding to the x-ray attenuation (or tissue density).
CT numbers are displayed as gray-scale pixels on the viewing monitor. White represents pixels with higher CT numbers (bone). Varying shades of gray are assigned to intermediate CT numbers e.g., soft tissues, fluid and fat. Black represents regions with lower CT numbers like lungs and air-filled organs.

Conventional (also called analog, plain-film or projectional) radiography is a fundamental diagnostic imaging tool in the detection and diagnosis of diseases. X-rays reveal differences in tissue structures using attenuation or absorption of x-ray photons by materials with high density (like calcium-rich bones).
Basically, a projection or conventional radiograph shows differences between bones, air and sometimes fat, which makes it particularly useful to asses bone conditions and chest pathologies. Low natural contrast between adjacent structures of similar radiographic density requires the use of contrast media to enhance the contrast.
In conventional radiography, the patient is placed between an x-ray tube and a film or detector, sensitive for x-rays. The choice of film and intensifying screen (which indirectly exposes the film) influence the contrast resolution and spatial resolution. Chemicals are needed to process the film and are often the source of errors and retakes. The result is a fixed image that is difficult to manipulate after radiation exposure. The images may be also visualized on fluoroscopic screens, movies or computer monitors.
X-rays emerge as a diverging conical beam from the focal spot of the x-ray tube. For this reason, the radiographic projection produces a variable degree of distortion. This effect decreases with increased source to object distance relative to the object to film distance, and by using a collimator, which let through parallel x-rays only.
Conventional radiography has the disadvantage of a lower contrast resolution. Compared with computed tomography (CT) and magnetic resonance imaging (MRI), it has the advantage of a higher spatial resolution, is inexpensive, easy to use, and widely available. Conventional radiography can give high quality results if the technique selected is proper and adequate. X-ray systems and radioactive isotopes such as Iridium-192 and Cobalt-60 for generating penetrating radiation, are also used in non-destructive testing.

See also Computed Radiography and Digital Radiography.

The dynamic range describes the range of x-ray intensities a detector can differentiate. A high dynamic range provides the discrimination between small differences in x-ray attenuation.
A current CT scanner has approximately a dynamic range of 1,000,000 to 1 and 1,100 views or projections a second.

Different filter types are used in medical imaging to improve image quality.
Filter materials such as aluminum, iron or copper, located in the primary x-ray beam between tube and collimator, filter out lower energetic x-rays (for example bow-tie filter). Filters partially absorb or attenuate the x-ray beam to prevent radiation overexposure. The sum of filtration consists of inherent and added filters. This filtration affects the beam energy and ability to penetrate materials.
Mathematical filter procedures are used for the convolution of the attenuation profiles and reconstruction of computed tomography (CT) images.

X-rays contain a range of energies (polychromatic photons), the higher energies pass through the patient, the lower energies are absorbed or scattered by the body. Ideally, the x-ray beam should be monochromatic or composed of photons having the same energy. Strong filtration of the beam results in more uniformity. The more uniform the beam, the more accurate the attenuation values or CT numbers are for the scanned anatomical region.
There are two types of filtration utilized in CT:
Inherent tube filtration and filters made of aluminum or Teflon are utilized to shape the beam intensity by filtering out the undesirable x-rays with low energy. Filtration of the x-ray beam is usually done by the manufacturer prior to installation. The half value layer provides information about the energy characteristics of the x-ray beam. Too much filtration produces a loss of contrast in the x-ray image.
A mathematical filter such as a bone or soft tissue algorithm is included into the CT reconstruction process to enhance resolution of a particular anatomical region of interest.