A computed tomography (CT) of the abdomen images the region from the thoracic diaphragm to the pelvic groin. The computed tomography technique uses x-rays to differentiate tissues by their different radiation absorption rates.
Oral contrast material can be given to opacify the bowel before scanning. An i.v. injection of a contrast agent (x-ray dye) improves the visualization of organs like liver, spleen, pancreas and kidneys and provides additional information about the blood supply.
Spiral- or helical CT, including improvements in detector technology support faster image acquisition with higher quality. Advanced CT systems can usually obtain a CT scan of the whole abdomen during a single breath hold. This speed increases the detection of small lesions (caused by differences in breathing on consecutive scans) and is beneficial especially in pediatric, elderly or critically-ill patients.
Changes in patient weight require variations in x-ray tube potential to maintain constant detector energy fluence. An increased x-ray tube potential improves the contrast to noise resolution (CNR).

An abdominal CT is typically used to help diagnose the cause of abdominal pain and diseases such as:
Other indications for CT scanning of the abdomen/pelvis include planning radiation treatments, guide biopsies and other minimally invasive procedures. Advanced techniques include for example 3D CT angiography, multiphasic contrast-enhanced imaging, virtual cystoscopy, virtual colonoscopy, CT urography and CT densitometry.

See also Contrast Enhanced Computed Tomography.

(DQA) This procedure is used by system operators to verify an x-ray system, gamma camera, or CT scanner operation based on relevant image quality parameters like e.g., geometric distortion, x-ray yield, signal to noise ratio. The quality assurance should carry out according to instructions of the manufacturer.

See also Acceptance Checking, Calibration and Calibration Factor.

(EDP) The term electronic data processing describes the automated processing of commercial data by computer systems.

See also Boot Terminal, Anticoincidence, Electronic Noise, Impedance Matching, Demodulator, and Hard Disk.

Grids are used in a test phantom to check the quality of x-ray images. Such a grid may consist for example, of gold structures on a silicon surface and a grid period length of 2 micrometer with space wide in between of 1 micrometer.
Filter grids are also used in x-ray imaging to reduce noise contributed by scatter.

Tomography is imaging by sections or sectioning to obtain images of slices through objects like the human body. Tomography is derived from the Greek words 'to cut or section' (tomos) and 'to write' (graphein). A device used in tomography is called a tomograph, while the image produced is a tomogram.
The first medical applications utilized x-rays for images of tissues based on their x-ray attenuation coefficient. The mathematical basis for tomographic imaging was laid down by Johann Radon. This type of imaging is used in different medical applications as for example computed tomography, ultrasound imaging, positron emission tomography and magnetic resonance imaging (MRI) also called magnetic resonance tomography (MRT).
Conventional x-ray tomographic techniques show organ structures lying in a predetermined plane (the focal plane), while blurring the tissue structures in planes above and below by linear or complex geometrical motion of the x-ray tube and film cassette.
Basically, computed tomography is the reconstruction of an image from its projections. In the strict sense of the word, a projection at a given angle is the integral of the image in the direction specified by that angle. The CT images (slices) are created in the axial plane, while coronal and sagittal images can be rendered by computer reconstruction.

See also Zonography, Computed or Computerized Axial Tomography, Resolution Element, Radiographic Noise, Intravenous Pyelogram.