The display matrix is the matrix in the displayed image and can be equal to or larger than the reconstruction matrix size due to interpolation procedures. This array of rows and columns of pixels is typically between 512 x 512 and 1024 x 1024.

Different filter types are used in medical imaging to improve image quality.
Filter materials such as aluminum, iron or copper, located in the primary x-ray beam between tube and collimator, filter out lower energetic x-rays (for example bow-tie filter). Filters partially absorb or attenuate the x-ray beam to prevent radiation overexposure. The sum of filtration consists of inherent and added filters. This filtration affects the beam energy and ability to penetrate materials.
Mathematical filter procedures are used for the convolution of the attenuation profiles and reconstruction of computed tomography (CT) images.

X-rays contain a range of energies (polychromatic photons), the higher energies pass through the patient, the lower energies are absorbed or scattered by the body. Ideally, the x-ray beam should be monochromatic or composed of photons having the same energy. Strong filtration of the beam results in more uniformity. The more uniform the beam, the more accurate the attenuation values or CT numbers are for the scanned anatomical region.
There are two types of filtration utilized in CT:
Inherent tube filtration and filters made of aluminum or Teflon are utilized to shape the beam intensity by filtering out the undesirable x-rays with low energy. Filtration of the x-ray beam is usually done by the manufacturer prior to installation. The half value layer provides information about the energy characteristics of the x-ray beam. Too much filtration produces a loss of contrast in the x-ray image.
A mathematical filter such as a bone or soft tissue algorithm is included into the CT reconstruction process to enhance resolution of a particular anatomical region of interest.

(MIP) CT Angiography images can be processed by maximum intensity projection to interactively viewing volumes of data, where the CT number of each pixel is given by the minimum CT number through the volume. The MIP connects the high intensity dots of the blood vessels in three dimensions, providing an angiogram that can be viewed from any projection. Each point in the MIP represents the highest intensity experienced in that location on any partition within the imaging volume. For complete interpretation the base slices should also be reviewed individually and with multiplanar reconstruction (MPR) software. The MIP can then be displayed in a Cine format or filmed as multiple images acquired from different projections.

The pitch factor is a selectable CT parameter. The definition depending on the IEC standards is the ratio of the table speed per rotation and the total collimation.
The choice of pitch factor is determined on practical considerations and on the availability of the computed tomography algorithms and parameters for image reconstruction.

See Pitch.